CHE 433: Thermodynamics Assignment, UiTM, Malaysia Velocity is an intensive property of a system and One kilogram of water at a temperature of 225°C and 500 kPa has a volume of 0.078405 m3
University | Universiti Teknologi MARA (UiTM) |
Subject | CHE433: Thermodynamics |
Question 1
State whether the statements below are TRUE or FALSE. Give an explanation to justify your answer.
i. Velocity is an intensive property of a system.
ii. One kilogram of water at a temperature of 225°C and 500 kPa has a volume of 0.078405 m3.
iii. Given two identical masses in a rigid tank and piston-cylinder device, the amount of heat required to heat up the piston-cylinder device is higher than the rigid tank at the same temperature difference.
iv. Enthalpy of vaporization decreases with pressure.
v. Van der Waals equation of state would predict less accurate state functions as compared to Ideal Gas equation of state.
Question 2
a. A piston-cylinder device containing air undergoes a cycle that is made up of three processes as shown in Figure 1. The relationship for the adiabatic process is given as PIA = C, where k is the specific heat ratio. If the air is an ideal gas with a mass of 0.5 kg and a specific heat constant is assumed, calculate the heat transfer for each of the processes (in kJ).
Are You Searching Answer of this Question? Request Malaysian Writers to Write a plagiarism Free Copy for You.
Recent Solved Questions
- A small new software development project at company SRT Enterprise has five major activities: Production Operation Management Home Work, UUM, Malaysia
- BBCA1033 Introduction to Accounting Assignment, CUM, Malaysia
- Managerial Finance Management and Investment Analysis Assignment Malaysia
- LAW201: Company Law Assignment, HU, Malaysia The landmark company law case of Saloman v Saloman & Co Ltd held that Mr Saloman the founder of the company
- Thinking Skills Essay, UON, Malaysia A team of five persons is responsible for negotiating the prices of cables that suppliers provide to your company
- TME303: Figure 1(a) and (b) shows a robotic arm used in automotive industry for painting and welding application: Automation And Robotics Assignment, WOU, Malaysia
- FPIT1083: Introduction to Computer Networks Coursework, TARC, Malaysia You, as a network engineer, have been required to design a network topology for the company
- KNS2163: Geotechnical Engineering Assignment, UMS, Malaysia Work to remediate failed slope along Jalan Sebauh, Bintulu is proposed and The affected slope is along a 5 km section of the road
- Program and Portfolio Management Assignment, CU, Malaysia Developing a Business Strategy and Develop an organisational strategic plan using strategic management models
- Discuss one of the emotion theories in psychology which exist and how nurses experience: Psychology and sociology for nurses Assignment, OUM, Malaysia